Deposits can be applied from .25 – 1,000 microns thickness for a wide range of applications. The thinner deposits being used to substantially increase the life of components in wear applications or corrosive environments, and the thicker deposits being used for salvage and repair of worn, damaged or mis-machined components.
Hard Chrome is classed as a “COLD” process, the operating temperature of 50 – 60°C ensures no detrimental effects to the physical or mechanical properties of the base materials. Hard Chrome can be deposited successfully and advantageously onto most metallic substrate materials.
Excellent Wear Resistance
Good Corrosion Resistance
Non Fretting Anti-Galling
Superfinishing to Mirror Finishes
Thinwall Technology or Heavy Build-Up
0.25 – 1,000 Micron Thick
Grinding and Polishing Service
Electro-deposited Chrome is extremely hard, with typical values of 850 – 1050 HV (63 – 70 HRc), hence the term “Hard” Chrome. This makes it an excellent coating for wear resistant and abrasion resistant applications such as Moulds and Dies, Punches, Bearing and Seal surfaces, and sliding components.
Hard Chrome has a very low coefficient of friction, approx. one half that of Steel. The coefficient against Steel of 0.16 lubricated (0.21 dry), makes it ideally suited for such applications as Bearing and Seal surfaces, and machinery components.
The high hardness and low frictional properties of Hard Chrome provide it with extremely good resistance to abrasive and erosive wear, extending the life of components such as Moulds, Dies and Punches etc, up to ten times in most cases.
Hard Chrome has an extremely high resistance to atmospheric oxidation, and a good resistance to most oxidising and reducing agents.(with the exception to Chlorides and other Halides), hence its wide-spread use in the Food and Chemical Industries.
Hardchrome Engineering offer some of the largest capacities available, with 16 tonne lifting facility and plating tanks capable of accepting components up to 8.0 metres in length and 1.3 metres diameter.
Since Hard Chrome deposits are readily removed with chemical strippers, without detrimental effect to the base material, the part can be stripped and re-plated repeatedly, when wear shows, without loss or damage to the base part. This is a significant advantage for high wear, high cost parts such as Plastic Moulds and Dies where abrasive filled plastics are used.
Hard Chrome deposits can be successfully finished by grinding, linishing or polishing.
Hydraulic and Pneumatic Piston Rods and Cylinders
Plastic and Rubber Rolls, Moulds, Dies, Screws, etc.
Automotive and Mechanical components
Press Tools and Punches
Print Cylinders and Plates
Valves, Gates and Bodies
Timber and Paper
Pump Shafts and Rotors